Cobra 4600 CAN, Installation Manual

Page: 18 / 20

INSTALLATION MANUAL 4600 CAN/PLIP
22
A. Power the main unit by connecting the 26 ways connector.
B. Connect the main unit blue wire to GND (only when a wireless siren is
fi tted).
C. Open the bonnet.
D. Connect the siren blue wire to GND (if not already grounded through the additional bonnet
pushbutton).
E. Disconnect the siren 6 ways connector, then plug it again.
F. Within 60 s turn the ignition key ON, an audible signal con
fi rms that the siren has been stored in the system.
G. Turn the ignition key OFF and disconnect the BLU wires of the main unit and of the siren from GND (if grounded
through the additional pushbutton simply open the bonnet).
Check the system functionality arming the system and triggering the alarm to check the proper sounding of the siren.
12. - DOCUMENTS HANDOVER.
Be sure the user manual and the PIN code card is placed in the glove compartment and carry out a full functionality
demonstration to the customer.
13. - SYSTEM TECHNICAL SPECIFICATIONS.
The manufacturer shall not be liable for any faults or malfunctions in the anti-theft device and/or in the electrical system
of the vehicle due to incorrect installation and/or to failure to comply with the indicated technical speci
fi cations. The
system must only be considered as a deterrent agaist theft attempts.
TECHNICAL SPECIFICATIONS 4600
Rated supply voltage +12 V DC
Operating voltage +8 V ÷ +16 V DC
Current consumption (central unit, LED and siren) disarmed 8 mA
Current consumption (central unit, LED and siren) armed 12 mA
Central unit operating temperature - 40 °C + 85 °C
Siren operating temperature - 40 °C + 85 °C
Self power supply Lithium Battery 6 V 1300 mAh
Loudspeaker sound pressure level >115 dB @ 1m
Siren sound pressure level >114 dB @ 1m
- Central dimensions 91x69x35 mm
- Siren dimensions 113x79x45 mm
Trasmitter battery / Cobra Driver Card Lithium Battery 3 V CR2032