Figure 29
AIR SCREW ADJUSTMENT:
Adjust for maximum idle speed
The air adjustment screw is located on the left side of the carburetor. It is the
smaller of the two adjustment screws and requires the use of a small flat blade
screw driver for adjustment. After adjusting for maximum idle speed, use the idle
screw to adjust the desired idle speed.
NOTE:
If the air screw requires more than 3 turns out, replace the pilot jet for one that is
one size leaner (smaller number) then readjust the air screw.
IDLE ADJUSTMENT:
Adjust for desired idle speed
The idle speed screw is located on the left side of the carburetor. It is the larger
of the two screws on the side of the carburetor and is unique with its knurled
head for easy fingertip adjustment. To raise the idle, turn the screw in, clockwise,
(in 1/4 turn increments) and rev the engine after each adjustment. To lower the
idle, turn the screw counter-clockwise.
TOP END JETTING:
Adjust for clean full throttle acceleration
Jet your top end (main jet) based on the acceleration of your Cobra Motorcycle
on the longest straight at the track. Observe any of the lean or rich symptoms
(spark plug appearance and bike performance) listed above and change your
jetting accordingly.
PART THROTTLE
Adjust for desired acceleration
Using an area of the track that allows the rider to operate and mid throttle and
transition (accelerate, or ‘roll on’) from closed, or mostly closed throttle, to a
larger throttle opening. Observe the rich and lean symptoms listed above.
Adjust the jet needle position by moving the clip from its current position (move
the clip higher on the needle to make the bike run leaner, or move the clip lower
on the needle to make the bike run richer) to one higher or lower.
47
Summary of Contents for 2008 ECX70
Page 1: ......
