®
23801 E. La Palma Ave., Yorba Linda, Ca 92887 Ph. 714.692.8180, Fax. 714.692.5016
www.cobrausa.com
04/17
2
®
Instruction Manual >
06-0467 - 01B / 02B / 03B / 04B
Page 2 of 2
7.
Position the mounting plate over the velocity stack (with the welded tube toward inside) and secure using
(3) supplied M6 x 25mm buttonhead bolts and (3) internal tooth lock washers, finger tighten only, Figure 3.
8.
Install the supplied support bracket to the two threaded bosses near the base of the cylinders using the (2)
supplied M6 x 12mm buttonhead bolts. Secure the support bracket to the mounting plate using (1) supplied
1/4"-20 buttonhead bolt, and finger tighten. See Figure 4.
9.
Fully tighten the (3) M6 x 25mm allen bolts, from Step 7, followed by the support bracket bolts, from Step 8.
10.
Attach the lower hose and hose clamp that was disconnected in Step 2 to the tube on the mounting plate.
Install idle adjuster onto the support bracket retaining tab. Reconnect the air temperature sensor connector.
11.
Insert the round intake screen into the black ring so the screen sits inside the edge of the ring. Place the
ring and screen between the legs of the naked black intake cover as shown in Figure 5.
12.
Place the naked intake cover, ring and screen assembled in Step 11, over the air filter and align each leg to
the base mounting plate threaded holes. Be sure screen sits at a 45 ° angle to the bottom leg, and C/V
logo'd leg is at the upper left position. Insert the (3) supplied 1/4"-
20 x 1/2” buttonhead bolts through the
intake cover and into the base mounting plate, see Figure 5. Double check all parts are aligned properly
and tightened securely.
DOCUMENT NO. 0018
REV. A
FIGURE 3
VELOCITY STACK
INSTALLED
SENSOR
W/ O-RING
MOUNTING
PLATE
(3) SUPPLIED M6 X 25mm ALLEN BOLTS
& INTERNAL TOOTH LOCK WASHERS
SUPPLIED M5
ALLEN BOLT
FIGURE 4
SUPPORT
BRACKET
(2) SUPPLIED M6 X 12mm
BUTTONHEAD BOLTS
1/4”-20 X 1/2”
BUTTONHEAD BOLT
CALIFORNIA CUSTOMERS:
In California, aftermarket parts that have been identified specifically
as replacement parts or that have received an Air Resources
Board Executive Order may be used on street motorcycles.
All other emissions related aftermarket parts are for competition
use only. A list of replacement parts and EO parts, and
corresponding fitment is provided at: www.cobrausa.com
FIGURE 5
MOUNTING PLATE
ASSEMBLY
INTAKE SCREEN
(3) ¼”-20 X 1/2”
BUTTONHEAD
BOLTS
C / V LOGO'D LEG
POSITIONED HERE
INTAKE COVER
(NOTE: DESIGN WILL
VARY BASED ON
PART NUMBER)
K&N
®
VENTURI AIR FILTER
INTAKE RING
CLEANING INSTRUCTIONS:
To clean your black air intake system use a liquid
based soap detergent, such as dishwashing soap
applied with a soft cloth and rinse with clean water.
Note: Avoid abrasive cleaning methods such as
granular or dry cleansers, simple green, Scotch-Brite
or steel wool pads. Abrasives may breach the
coating and shorten life.
