36 English
Setup Mode Programming
Operating Your Radio
Active Channel Map Icon
Set Channel Map
Channel Up/Down Button
International/Canada/USA Channel Maps
Three (3) sets of VHF Channel Maps have been established
for marine use in the USA, Canada, and the rest of the world
(International). Most of the channels are the same for all
three (3) maps, but there are definite differences (see table
on pages 16 through 23). Your radio has all three (3) maps
built into it and will operate correctly in whichever area you
choose.
To Set Channel Map Operating Area:
1.
The
Channel Map
mode is the first mode that
begins the
Marine (VHF) Setup
programming.
2. U, I
and
C
will display, with the current setting (the
I
icon is the default) flashing.
3.
Press
Channel Up/Down
button to select the
I, C
or
U
icon.
4.
Press
Call/Enter/Setup
button to save this entry and
move to the next setup programming mode.
NOTE
One (1) or two(2) of the channel maps might have
been disabled for sales of this radio in some
countries.
Setup Mode Programming
•
The following series of procedures is designed to allow you to set the programmable
features of your radio. Correctly following these steps results in a minimal amount
of radio setup programming time.
NOTE
When in the
Setup
mode, if you stop programming for longer than 15 seconds,
your entry will be saved and the radio will go back to the
Marine Standby
mode. When you return to
Setup
mode and continue programming, you will see
the last “value” displayed. While in the
Setup
mode, you will not receive any
signal reception.
Programming these features will allow you to customize certain features of this
radio to enhance your “On-Water” audio needs.
Start from
Marine Standby
mode to begin
Marine (VHF) Setup
programming. Press
and hold the
Call/Enter/Setup
button for two (2) seconds to enter the programming
mode.
Marine (VHF) Mode Programming
MRHH415EU-Body.qxp:400_Body 12/15/06 10:00 AM Page 36
