Cobiss Metapace L-42DT, User Manual, Page: 10 / 24

Metapace L-42DT User Guide VIF
6/20
© IZUM, 30. 11. 2016, VIF-NA-BG-128, V2.0
2.4 Connecting and installing the printer
There are four ways to connect the METAPACE L-42DT printer and get it ready to work. To
connect it to the computer, use the USB-B cable (enclosed) or the serial cable. To connect it to
the network, use the network cable (RJ45). To use the printer with several workstations, it is
recommended to connect it to the local network.
When installing the printer, use the drivers available:

on the enclosed CD or

at the following link:
1
http://vbbghome.bg.cobiss.net/preporuki_za_oborudvane/
The printer has two buttons: FEED/CANCEL and PAUSE, as well as two tricolour LED
indicators. The LED indicators indicate different operation modes and also signal errors. Use the
FEED/CANCEL button to move labels forward and start testing, calibration and configuration
(factory default settings). Use the PAUSE button to pause printing.
If you need help when using the printer, call the call centre (02/2520 333) or send an e-mail to
podpora@izum.si.
2.5 Printer operation
2.5.1 Manual settings
To change settings, use the FEED/CANCEL and PAUSE buttons and observe the LED
indicators:
Printer state
before operation
Button
Operation procedure
Printer operation
mode
FEED/
CANCEL
PAUSE
Power OFF Press - Turn printer on. Hold the button until
printer starts self-test printing. Self-test Printing
Mode
Stand by Press - Press the button and release
immediately. Feed Mode
Stand by - Press Press the button for two seconds. Entry to
Configuration Mode
During printing Press - Press the button for two seconds and
continue to hold. Print Cancel Mode
During printing - Press Press the button and release
immediately. Print Pause Mode
1
http://www.seagullscientific.com/drivers/printer-driver-features/?m=ml-42dt