COBHAM Sea Tel 4010W-17, Installation Manual

Page: 25 / 141

Installation 4010W-17 Installation Manual
3-5
15. Remove the rubber bar from the top of the Roxtec®
Multidiameter® blocks.
16. Remove the Roxtec® Multidiameter® blocks from
the cable mounting frame.
17. Pass the coaxes and power cable through the cable
mounting frame.
HINT: Again, It may be easier to connect, or tie-wrap,
the coaxes and power cable temporarily.
18. Re-install the cable mounting frame onto cable
passage channel using the four screws and flat
washers that were removed in step 7 above. .
19. Peel layers out of the upper and lower Roxtec®
Multidiameter® blocks to provide an opening in the
block that is just smaller than the outer diameter of
the cable that will pass through it. When
compressed the block should provide clamping force
on the cable and prevent it from moving in the block.
20. Two cables may be passed through each of the
Roxtec® Multidiameter® CM-20w40 blocks
provided.
21. If cables larger than 1.65cm/0.65in outer diameter
will be used, larger single-cable Roxtec®
Multidiameter CM-40 10-32 blocks are available to
allow three cables of up to3.25cm/1.28in diameter
to be used. The
rubber bar
and the
three double-
cable
Roxtec® Multidiameter blocks will be
replaced
by the
three larger Roxtec®
Multidiameter blocks
.