Supported commands
98-148248-C
Appendix E: Command line interface
E-3
EEEE
Command line interf
ace
E.2.1 config
E.2.2 demo
E.2.3 dual_antenna
Command
Description
config
Shows the sub commands available, including a short
description.
config pending_list
Shows the number of pending changes.
config current_list
Shows the values for the current satellite profile, antenna
and some tracking information.
config discard
Discards all pending changes.
config activate
Use this command to save and activate the pending
changes in the SAILOR VSAT system.
Table E-2: UCLI command:
config
Command
Description
demo start
Starts a demo pattern where the antenna will turn azimuth,
elevation and cross elevation until it receives the command
demo stop.
demo stop
Stops the antenna demo pattern.
demo reset
Resets the antenna to angle 0.
Table E-3: UCLI command:
demo
Command
Description
dual_antenna mode
Shows the current dual antenna mode
• single
• master
• slave
dual_antenna status
• Shows the current dual-antenna mode status
• active
• inactive
Table E-4: UCLI command:
dual_antenna
Summary of Contents for SAILOR 60 GX
Page 1: ...Cobham Public SAILOR 600 VSAT Ka SAILOR 600 VSAT Ka High Power Installation manual...
Page 116: ...Software update 8 12 Chapter 8 Service 98 148248 C Figure 8 11 Verifying software update...
Page 181: ...Telenor antenna approval G 4 Appendix G Approvals 98 148248 C...
Page 192: ...98 148248 C www cobham com satcom Cobham Public...