Quick Start Guide
INCA Repeater
www.cobham.com/tcs
80011422
Sept. 2014 - Version 1.4
INCA Repeater Hardware Setup
To setup the INCA Repeater hardware:
1. Connect an antenna to the ANT RX BNC connector.
Note:
This antenna is NOT required when operating the INCA Repeater in TX mode.
2. Connect an antenna to the ANT TX BNC connector.
Note:
This antenna is NOT required when operating the INCA Repeater in RX mode.
3. Connect a remote control antenna to the REMOTE BNC connector, if Remote Control or Remote Repeat is required.
4. Connect a 12 V DC power supply to the 12 V DC IN Lemo jack.
Note:
Do NOT connect the INCA Repeater directly to AC power. The INCA Repeater supply voltage range is 10.0 V to 15.6 V DC.
Only use the included power supply or an external battery.
5. Connect the required audio in or audio out cables depending on the operating mode configuration.
6. Slide the power switch to the left to turn On the INCA Repeater. In normal configuration, the LED will illuminate green.
1
4
2
5
3
6
INCA Repeater Software Configuration (continued)
7. Set the Remote Control option in the Remote Tab, if required.
Note:
It is possible to control different functions of the INCA Repeater with the X-IDER and/or INCA GM Keyfob, if enabled.
8. Set the Remote Repeat option in the Remote Tab, if required.
Note:
It is possible to control installed transmitter(s) by rebroadcasting the remote commands from and X-IDER and/or INCA GM Keyfob
through the INCA Repeater, if enabled.
9. Set additional options in the General Tab, if required.
Note:
Refer to the User Manual for additional information on the options available in the General Tab.
7
8
9
