Doc. No:
GR716-DEV-QSG
Issue:
0
Rev.:
2
Date:
2019-05-02
Page:
11 of 31
Status:
Draft
3
BOARD CONFIGURATIONS
3.1
Overview
The primary sources of information are the GR716 Development Board User's Manual [RD2] and
the GR716 Data sheet and User's Manual Error: Reference source not found. Before start using the
GR716, clock and reset sources have to be installed, bootstrap signals need to be set correctly and
the desired interfaces have to be enabled. The GR716 interfaces shares some of the IO pins due to a
limited number of pins. For that reason, the pin multiplexing has to be set up depending on the
desired interfaces and memory configuration.
3.2
Default configuration
This guide provides one default and two alternative configurations. The default configuration
provided assumes one mounted GR716-CONFIGx and one mounted GR716-BOARD board
mounted in slot #1. The debug links is UART over FTDI via the front panel of the GR716-CPCI-
GR716-DEV board.. General I/O, SPI flash Prom and Debug-UART are used. The complete default
configuration can be found in Error: Reference source not found. If this is your first time using the
GR716 Development Board, please use this configuration as a starting point.
© Cobham Gaisler AB
Default configuration
To achieve the default configuration please follow the instructions on each box note like
this one.
