Doc. No:
GR716-DEV-QSG
Issue:
0
Rev.:
2
Date:
2019-05-02
Page:
12 of 31
Status:
Draft
3.3
Plug-on configuration boards
To avoid misconfiguration and driver contamination the GR-CPCI-GR716-DEV development board
implements a simple scheme where the user can create custom plug-on boards to select connections
between the GR716 device and interface driver/source. The plug-on boards are refereed to as
GR716-CONFIG1 boards. This document describes 3 variants of the GR716-CONFIGx boards:
•
Configx – This is the configuration which enables connection all to interface
drivers/receivers on the GR-CPCI-GR716-DEV Development board.
•
Config0 – Enables GPIO, UART, MIL-1553, PacketWire, CAN, SPI Master and Slave,
SpaceWire and SPI4S over CMOS. Configuration also supports on-chip ADC and DAC
•
Config1 – Enables GPIO, MIL-1553, CAN, SPI Slave, external SRAM/FLASH/SPI
memory, external ADC/DAC interface. Configuration also supports on-chip ADC and DAC.
Figure 1 View of the board after configuration board is installed
© Cobham Gaisler AB
