To assemble the EXPLORER 6075LX
98-165591-B
Chapter 3: Assembly & start up
3-7
3333
Connect cables
1. Connect the RF cables:
(1)
BUC power cable
between the circular connector on the BUC and the MIL
connector marked
BUC M&C
on the antenna positioner.
(2)
Transmit
(Red, Tx) cable between the N connector on the BUC and the N-connector
marked
Tx
on the antenna positioner.
(3)
Receive
(Blue, Rx) cable between the LNB Receive port and the TNC connector
marked
Rx
on the antenna positioner.
2. Connect your power supply to the
DC Power
connector on the front of the Base Unit as
described in the next section
.
3. Connect the Ethernet cables as described below.
Cable type
: Use shielded LAN cable.
LAN ports:
There are four RJ-45 ports for making IP-data connections.
•
Service port on the left-hand side (Port 1) for system control via the web interface.
•
Two connectors (Port 2 and Port 3) for user PCs for Internet etc., configured by the
GX modem.
See the documentation from your service provider.
•
Management port (Port 4), e.g. for system control from a PC on a corporate
network.
Figure 3-12: Tx, Rx and BUC cables
Figure 3-13: DC power connector
(3) Rx cable
(blue)
(2) Tx cable
(red)
(1) BUC power cable
