To assemble the EXPLORER 6075LX
98-165591-B
Chapter 3: Assembly & start up
3-8
3333
To connect power
We recommend using
the EXPLORER 6000 Series Power Supply
(part number
403160P).
To connect the EXPLORER 6000 Series Power Supply:
1. Connect the circular connector from the EXPLORER 6000 Series Power Supply to the DC
Power connector on the Base Unit.
2. Connect the line cord on the EXPLORER 6000 Series Power Supply to a standard AC
outlet (90-305 VAC). The connector is a Schuko (EU) connector. A Schuko to US adapter
is included with the power supply.
To connect using the included power cable:
For applications where you cannot use the EXPLORER 6000 Series Power Supply, an open-
ended cable (2.5 m) is supplied with your EXPLORER 6075LX.
1. Connect the circular connector on the supplied cable to the DC Power connector on the
Base Unit.
2. Connect the
black wire to GND
and the
red wire to V+ from the DC power
supply
.
3. If you are not using the supplied cable, or you need to extend the cable, use minimum
AWG14
for the power supply wires.
Note
By default, the web interface can only be accessed via Port 1 or Port 4
.
The WLAN connection must be configured, see
Note
The Enable signal (2-) is connected to GND (2+) in the cable connector on the
EXPLORER 6000 Series Power Supply, which means that power to the EXPLORER
6075LX is controlled only by the ON/OFF button on the Base Unit. There is no
remote on/off function.
For pinout, see Figure 3-14.
Note
If you need a longer cable, an extension cable (10 m) is available from Cobham
SATCOM (part number 403160P-010).
Note
The Enable signal (
2-
in Figure 3-14) is connected to GND (2+) in the cable
connector, mounted on the included power cable. This means that power to the
EXPLORER 6075LX is controlled only by the ON/OFF button on the Base Unit.
There is no remote on/off function.
