Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
3
-
24
R5 Owner’s Manual
COBALT
R5
BOWRIDER
S
ECTION
3
Check Engine Alarm
Appearance
- When the Check Engine Alarm is
received, the LCD display shows “
C E
” flashing.
Guardian Active Alarm
Appearance
- When the Guardian Active Alarm is
received, the LCD display shows “
C E
” flashing.
Helm Fault Alarm
Appearance -
When the Helm Fault Alarm is
received, the LCD display shows “
H F
” flashing.
2. BILGE BLOWER -
This switch activates the
engine compartment ventilation blower to remove
explosive fumes from the area. The blower must be
operated for a minimum of four minutes each time
before starting the engine. In addition, the blower
should be operated continuously when at idle or
running at slow speeds. The LED will illuminate if
the switch is ON.
3. BILGE PUMP -
This switch manually controls the
bilge pump.
4. INTERIOR LIGHTS -
This switch provides
illumination within the cockpit area.
5. DOCKING LIGHTS (Optional) -
This switch
operates the docking lights.
Docking lights are to be used for docking only. It is
illegal to use your docking lights while cruising.
6. HORN -
This switch activates the horn. Press the
switch to activate.
7. CAPTAIN’S CALL (Optional) -
This switch
determines the routing of the engine exhaust. In the
ON position, engine exhaust is routed through the
thru-hull pipes. This position produces the most
engine power, but is not acceptable near shore or
on inland lakes and rivers.
In the OFF position, engine exhaust is routed
through the hub of the propeller. This position
releases the exhaust underwater, providing a
quieter engine sound.
Be sure to check local regulations regarding noise
restrictions before operating this system.
8. UNDERWATER LIGHTS -
This switch provides
illumination of the underwater lighting.
9. PLATFORM LIGHTS -
This switch provides
illumination within the platform area.
10. ANCHOR / MOORING LIGHT -
All boats at
anchor or moored must display a proper white
anchor light.
The anchor light (all-around light) is the white light
that is installed into a receiver located aft of the
cockpit. The anchor light must be visible from 360°
and will remain on when operating the navigational
lights.
11. NAVIGATION LIGHTS -
For Inland Rules
only. Do not use in international waters
. You
must use your navigation lights and
anchor/mooring light when operating your Cobalt
boat between sunset and sunrise, and when
daytime visibility is limited. Check with your local
authorities for other requirements concerning the
use of navigation lights before operating your boat.
The navigation lights are identified by a red light on
the port side of the vessel and a green light on the
starboard side.
12. ACC -
This switch is available to operate
switched accessory items.
CAUTION
Avoid damage to the exhaust system.
DO NOT switch the routing of the
exhaust above 3,000 RPM.
NOTICE: Operate the boat
between sunset and sunrise
using your navigational lights.
Navigational lights are legally
required to indicate direction
and right-of-way at night.
NOTICE: DO NOT connect an
accessory drawing more than 10
amps to the accessory switch. A
hazardous situation or damage
to the electrical system can
occur.
Summary of Contents for R5 BOWRIDER
