13
Chapter 2
Setting up the Qube 2
This chapter guides you through the process of connecting and
configuring the Cobalt Qube 2 for your network and user community. A
typical setup process takes less than 15 minutes, after which you can
begin using all of the Qube 2 services.
If the Qube 2 has been configured previously for a different network,
refer to “Changing network configuration” on page 156 in Appendix A.
Qube 2 setup
The setup process occurs in two phases.
•
“Phase 1: Making the Connection” explains the physical connection
of the Qube 2 to a power source and the network.
•
“Phase 2: Setting up with the Web browser” explains the network
integration process and allows the administrator to select services
and create users and groups, using any browser-enabled computer.
Phase 1: Making the Connection
Connecting to the network
Connect the Primary Network Interface (10/100 BaseTX) of the Qube 2
to your local network with a twisted-pair ethernet cable; see Figure 5.
Figure 5 Network connectors
Locking
Secondary
power
socket
Network
Interface
Primary
Network
Interface
Serial port
Summary of Contents for Cobalt Qube 2
