BBG-1300-OM (V1.0)
BBG-1300-FR PRODUCT MANUAL
2-7
Installation and Setup
Installing Rear I/O Modules and Cards
Note:
Use care to pull front bezel assembly away from BBG-1300-FR chassis as
straight as possible. If bezel is pulled out unevenly, mounting tab(s) could
bend. This may result in needing to straighten the tab(s) before the bezel can
again mate with slots in the BBG-1300-FR chassis.
3.
(See Figure 2-6.) While holding the card by the card edges, align the card
horizontal such that the plastic ejector tab is on the right (component-side
facing up).
4.
Align the card with the side guides of the slot in which the card is being
installed.
5.
Gradually slide the card into the slot. When resistance is noticed, gently
continue pushing the card until its rear printed-circuit edge terminals
engage fully into the rear module mating connector.
CAUTION
If card resists fully engaging in Rear I/O Module mating connector, check for
alignment and proper insertion in slot tracks. Damage to card and/or Rear I/O
Module may occur if improper card insertion is attempted.
6.
Repeat steps 3 thru 5 for other card (if used).
7.
When card(s) is inserted in slot(s), re-install the front bezel assembly as
follows:
7.1
Align the mounting tabs on front bezel with mating slots on
chassis and making certain bezel is oriented with screw hole
aligning with chassis securing tab.
7.2
Push the front bezel assembly fully toward the chassis until
bezel is fully flush with chassis.
7.3
Start and lightly tighten retaining screw on underside of bezel.
Figure 2-5 Front Bezel Removal/Installation
Remove front bezel assembly by pulling bezel
straight away from BBG-1300-FR chassis.
Install front bezel assembly by aligning tabs with slots, and
then pushing bezel to mate with BBG-1300-FR chassis.
When pulling bezel from
chassis, make certain to pull
straight away from chassis.
Mounting tabs can be bent if
pulled unevenly. This may
require tab(s) to be bent
straight again.
Summary of Contents for BBG-1300-FR
Page 45: ......
