Cobalt Digital Inc BBG-1034-AUD-PRO-DSP, Product Manual, Page: 27 / 118

BBG-1034-AUDPRO-OM (V1.6) BBG-1034-AUD-PRO-DSP PRODUCT MANUAL
2-1
Chapter 2
Chapter 2
Installation and Setup
Overview
This chapter contains the following information:
•
Installing the BBG-1034-AUD-PRO-DSP (p. 2-1)
•
Rear Panel Connections (p. 2-2)
•
GPIO, Serial (COMM), and Analog Audio Connections (p. 2-5)
Installing the BBG-1034-AUD-PRO-DSP
Note: • Where BBG-1034-AUD-PRO-DSP is to be installed on a mounting plate (or
regular table or desk surface) without optional frame Mounting Tray
BBG-1000-TRAY, affix four adhesive-backed rubber feet (supplied) to the
bottom of BBG-1034-AUD-PRO-DSP in locations marked with stamped “x”.
If feet are not affixed, chassis bottom cooling vents will be obscured.
• Where BBG-1034-AUD-PRO-DSP is to be installed with optional frame
Mounting Tray BBG-1000-TRAY, do not affix adhesive-backed feet.
Installing Using BBG-1000-TRAY Optional Mounting Tray
BBG-1000-TRAY allows up to three BBG-1034-AUD-PRO-DSP to be
mounted and securely attached to a 1 RU tray that fits into a standard EIA 19”
rack mounting location. Install BBG-1034-AUD-PRO-DSP unit into tray as
described and shown here.
1.
If installing BBG-1034-AUD-PRO-DSP using optional frame Mounting
Tray BBG-1000-TRAY, install BBG-1034-AUD-PRO-DSP in tray as
shown in Figure 2-1.
2.
Connect the input and output cables as shown in Figure 2-3.