Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
5-6
336 Owner’s Manual
COBALT
336
DAY
CRUISER
S
ECTION
5
2. Take medium-bristled brush and dunk into the
soapy water.
3. Work around on SeaDek until dirt, etc. comes
up.
4. Rinse with water. Repeat if necessary.
To remove suntan lotion:
Use the all-purpose cleaner alone with a
medium-bristled deck brush.
1. Put small amount of the all-purpose cleaner on
oil.
2. Dip medium-bristled boat brush in warm water
and work around until oil is out.
3. Rinse with water. Repeat if necessary.
To remove fish blood:
Use 1 cup bleach to 1 gallon of warm water and
soft-bristled boat brush.
1. Mix bleach and water. Dip soft-bristled brush in
water.
2. In a circular motion, clean SeaDek until fish
blood is removed.
3. Rinse with water. Repeat if necessary.
4. If not effective, see steps to remove rust stains.
To remove rust stains:
Use a capful of MaryKate On & Off Hull & Bottom
Cleaner for fiberglass.
1. Apply on the rust stain and allow to soak for 3 to
5 minutes.
2. If necessary, use latex/nitrile gloves to massage
the cleaner into the brushed or embossed
texture of the SeaDek pad.
3. Rinse with water. Repeat if necessary. The rust
stain will eventually be removed.
DO NOT USE:
• Mineral spirits
• MaryKate Hull Cleaner (Use only for rust
removal; do not use as a general cleaner.)
• Acetone (If it must be used, avoid the
adhesives if possible.)
• Bleach (If used, dilute 1:1 with water.)
For best cleaning results, tend to all stains, spills
and leaks as soon as possible.
Deck and Hull Care
Paste wax* will help retard UV light damage. We
suggest three coats be applied at the end or the
beginning of the season, depending on the type of
winter boat storage (covered, enclosed storage
facility), and again mid-season.
To extend the life of your gelcoat finish, use a
Cobalt marine mooring cover totally covering the
top deck of the boat for maximum protection.
Additionally, if your boat is to be stored where the
sun is constantly on the side or transom of the boat,
you should consider having some custom skirting
made to complement the mooring cover.
Tonneau covers will supply adequate short term
protection to the interior, but will not protect the
gelcoat finish. Please check with your authorized
Cobalt dealer for more information on the subject.
NOTICE: With MaryKate Hull
Cleaner, be careful to avoid
getting this solvent on the sides
of the SeaDek pad. It could
damage the lamination or PSA.
CAUTION
Be careful with all cleaning products.
Wear vinyl or nitrile gloves and eye
protection.
* 3M carries a complete line of fiberglass care products.
Summary of Contents for 336
