Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
3
-
34
26SD Owner’s Manual
COBALT
26SD
SPORT
DECK
S
ECTION
3
ANCHOR LIGHT
To install anchor light insert pole into socket and
turn clockwise until it locks into place.
Cap the anchor light socket when the anchor light is
removed.
CRUISE CONTROL -
OPTIONAL
To operate the Cruise Control speed control
system, set desired speed. Once your boat reaches
the set speed, the Cruise Control will hold the
speed constant. For additional operating
information, refer to Cruise Control operator’s
manual in your owner’s packet.
BATTERY SWITCH
The dual battery switch provides isolation and
positive disconnect from the batteries to protect
against tampering, electrical fire hazards and
battery rundown. The switch should be in the ON
position rather than the COMBINE BATTERIES
position. This will keep one battery in reserve
should the other fail. You can operate the boat with
the switch in the COMBINE BATTERIES position,
but this is not recommended for extended periods.
In the OFF position, the boat will be isolated from
the batteries except for the automatic bilge pump.
A
WARNING
Avoid injury or death. DO NOT use the
cruise control feature as a means for
navigation or for
“
no hands
”
operation.
COB_0097_A
ON/OFF
MENU
PERFECTPA
SS
WAKEBOARD PRO
WAKBD 22 . 5 22 . 5
COB_0029_A
NOTICE: The purpose of dual
batteries is to keep one as a
spare. In the COMBINE
BATTERIES position, one larger
battery is essentially formed. If a
failure should occur with the
electrical systems or either
battery, both batteries will end up
discharged.
NOTICE: On dual battery
installations, there is a VSR
installed that will allow the engine
to charge the second battery. If
the battery is discharged below
9.5V DC, the VSR will not charge
the battery. For the engine to
charge the batteries in this
scenario, the battery switch will
need to be placed in the
COMBINE BATTERIES position
until a sufficient charge is
supplied to the battery to raise its
voltage above 9.5V DC. At that
time, the battery switch should be
returned to the ON position.