ASSEMBLY INSTRUCTIONS
300345KE (B2 & B3) - BOX 2 & BOX 3
300345KE (B1 - B3) - BOX 1 TO BOX 3
STEP 1
STEP 2
1.1) Place footboard panel (CN) upside down on soft surface. Loosen the bolts from metal plate to leave a gap of about
Align and fasten footboard leg (FN) to the pre-marking on the 5mm. Hook the left and right bed rail (DN & EN) onto the
bottom of footboard panel (CN) using short flat head
bolts.
screw (1) (as per diagram shown) and tighten with Phillips
head screw driver (NOT INCLUDED).
1.2) Align and fasten footboard support with leveler (HN) to
STEP 3
STEP 4
Align and fasten bed slat support with leveler (GN) to
Align and fasten the plat at the end of center rail (IN)
center rail (IN) using bolt (3) and tighten with small
to the bracket at headboard (AN) and footboard (FBN)
Allen wrench (4).
using short flat head screw (1) and tighten with Phillips
head screw driver (NOT INCLUDED). Then adjust
leveler on bed slat support to touch the floor.
www.coastercompany.com
ITEM : 300345KE (B1-B3)
PAGE 3 OF 4
footboard panel (CN) by turning clockwise until tight. Then
adjust leveler to touch the floor.
