HARDWARE IDENTIFICATION
A
CHEST
1PC
1
L- BRACKET
2PCS
2
CABLE TIE
1PC
3
LONG SCREW
1PC
4
SHORT SCREW
1PC
5
PLASTIC
ANCHOR
1PC
STEP 3
3.1) Attach one of the mounting brackets securely to the back edge of the chest. Use the short screw.
3.2) Determine where the chest is to be placed and mark location on the wall for the mounting bracket screw
hole approximately 2" below the bracket mounted to the edge of the chest.
3.3) Drill a 3/16" hole in the wall.Press the plastic anchor into the hole and gently tap until the flange on the
anchor is against the wall surface
3.4) Position the bracket and use the long screw to securely attach the bracket to the wall
3.5) Place the chest so the bracket on the back edge is in line with the bracket on the wall.
ANTI - TIPPING KIT
PARTS IDENTIFICATION
3.6) Lace an end of the cable tie down through each bracket. Bring both ends together and slide the beaded
end of the cable tie through the keyhole shaped slot on the other end until snug. Pull down on the beaded end
until it snap locks into the keyhole slot.
3.7) To double lock return the beaded end back through the keyhole as shown.
3.8) Check to make sure the cable tie is securely laced and locked to the brackets.
www.coastercompany.com
PAGE 4 OF 4
