( 7 )
Install Door Stop
The purpose of Door Stop (X) is to prevent the Door Panels from
hitting upon themselves
.
Partially open the Door Assembly. Measure and mark 2 inches from
hinge side as shown in figure below. Using a 1/8” drill bit, drill a pilot
hole thru center of Guide Track’s bottom (B). Using the pilot hole
you just drilled, secure Door Stop (X) to the Guide Track with one(1)
Door Stop Screw (Y).
Install Sill Magnet
Clean the Sill face with alcohol where Magnet (Z) will make contact
with the Sill (see figure below).
Align and bring together the magnet faces of pieces (Z & I) as shown
in figure. Remove backing from tape (z2) . . . step inside the shower
enclosure and close the Door Assembly. Apply pressure on magnet
holder to activate tape adhesion to Sill. Finish by running a 638PHPT
screw thru metals as shown in figure.
Leak Proof Your Installation
Run a bead of clear mildew resistant caulking down the full length of
each Wall Jamb
outside
where the Jambs meet the Walls. Now run
a bead
outside
where the Sill meets the curb. Follow caulking
manufacturer’s instructions before using shower (normally 24 hours).
Installation is now complete.
PARA_NEO_BIFOLD_12/23/99
Screws shown full scale for reference
