2
USER MANUAL ENGLISH
400-04650
ALU STAR
Deadweight of the cycle rack: 2.8 kg
Assembly instructions
)LUVWUHPRYHWKHHQGVFDSVZLWKDKDPPHUDQGSXQFK
a
8EUDFNHW
PD\
EHXVHGDVDQDOWHUQDWLYHLIDSXQFKLVQRWDYDLODEOH6HH)LJ
Mount the hand wheel
B
to the tubular bracket using the screw
G
and the spring
D
(Fig 1)
. The cycle
rack should be mounted to the front support bar using the enclosed U-bracket
U
and knurled nuts
M
(Fig 3)
.
Mount the cycle rackto the roof support. Mount the cycle rack to the rear support. Push the
T-slide
L
into the bottom of the profile rail. Place the cycle rack onto the roof support and align. Use
the assembly plate and the toggle nuts to attach the cycle rack. Place the clamp jaws of the
lower
plate
J
to the front sloping frame part of the cycle and tighten using the hand wheel
B
. Attach pivot
screw using the
l
ockable tog nut
A
.
Slide the belt guides
N
into place before installing the end caps
P
and t
ighten the wheels in the profile rail using the holding straps
H
(Fig )
.
Safety information
:
Check the screws for the first time after driving a short distance and then at regular intervals.
Please note that the load on the roof will change the driving properties of your vehicle during brak-
ing, in the case of side winds and when driving round bends. Adjust your driving speed according-
ly. In particular, observe the information provided by the manufacturer of the vehicle about the
permitted roof loads. Parts of the cycles, such as e.g. handlebars or pedals, should not protrude
over the edge of the roof. If not needed, the cycle rack should be dismantled for reasons of safety
for other road users and economy (petrol consumption). CAUTION: When the cycle is mounted,
note the greater height of your vehicle when entering underground car parks, tunnels etc. Before
setting off on your journey, always check that the attachments are all correct. IMPORTANT: Al-
ways use the supplied holding belt. Deadweight of the cycle rack: 2.8 kg
“More information https://www.caravansplus.com.au"
