2
TNG_HOWTO_PGMBLTPK_D0000080_2014_REVB How to Program a Tempest NG BeltPack 1.31.2014
Clear Memory (if applicable)
If you are programming existing BeltPacks to a new BaseStation, it is recommended you clear the memory off of each BeltPack.
Follow the steps below PRIOR to programming BeltPacks to a new BaseStation:
1.
On the BeltPack, Press MENU
2.
Select Belt Settings>Tech Menu
a.
You’ll be prompted with a warning – press ENTER twice to proceed past the warning screen
3.
Select Set Defaults>Clear Memory
a.
Press ENTER to clear
b.
You’ll be prompted with a warning ‘Are you sure?’ – press ENTER to proceed through warning
c.
The BeltPack should reboot itself after clearing memory
4.
Repeat steps 1-3 for each BeltPack that is to be programmed to the new BaseStation
Slot Assignment
If you “Clear Memory” or if your BeltPack displays “Slot Occupied” you will need to reset the slot assignment for that BeltPack. Each
BaseStation has 5 slots (01-05) and they cannot support more than one BeltPack with the same slot number. Follow these steps to
set the appropriate slot assignment for the BeltPack:
1.
On the BeltPack, Press MENU
2.
Select Belt Settings>Tech Menu
a.
You’ll be prompted with a warning – press ENTER twice to proceed past the warning screen
3.
Select Base Slot
a.
Use volume knob to scroll thru slot assignments to desired slot
b.
Press ENTER to save
4.
Press MENU to back out to the main screen; BeltPack should be logged in at this point
5.
Enter security code
Set Security Code
Each system has a unique security code assigned to it during the manufacturing process. Programming a BeltPack does not transfer
this data, so it must be done manually. Follow the steps below in order to find the code, and then set your recently programmed
BeltPack to the same security code:
1.
Press MENU>Select Base
a.
Confirm that there is a check beside the base name; the BaseStation must be selected for the Security Code to set
correctly
2.
Press MENU repeatedly until you’ve backed out to the main status screen
3.
On an existing BeltPack, press MENU
4.
Select Belt Settings>Tech Menu
a.
You’ll be prompted with a warning – press ENTER to proceed past the warning screen
5.
Select Security>Security Code
a.
The 4-digit security code should be displayed on the LCD screen (e.g. FB55)
b.
Make a note of the code and press MENU repeatedly until you’ve backed all the way out to the main status screen
of the BeltPack
6.
On the newly programmed BeltPack, follow the same MENU path in steps 2 and 3 to access the Security Code screen
7.
Once on the Security Code screen, use the VOL knob to position the cursor under the digit you need to change
8.
Press ENTER to access that digit and then use the VOL knob to scroll to the proper letter or number needed
9.
Once you have scrolled to the proper digit, press ENTER to save the change
10.
Use the VOL knob to move the cursor to the next digit that needs changing; follow steps 6 and 7 for each digit that needs
adjusting
11.
Once complete, press the MENU button until you’ve backed out to the main status screen
