12
EN
GL
IS
H
5. To replace the drive belt the lower blade pulley
wheel must be removed. Find the circlip that
holds the blade pulley wheel onto the shaft and
remove it using a pair of circlip pliers.
6. Pull the blade pulley wheel off the shaft.
7. Place the new belt over the motor’s drive pulley wheel and round the shaft which the blade pulley wheel is
mounted on. Replace the blade pulley wheel and refit the circlip. Make sure that the drive belt is fully located
in the grooves of either the inner or outer wheels.
8. Tension the belt by pivoting the motor back into place and secure it with the two bolts.
Note!
• Always unplug the band saw before making any adjustments or repairs and whenever
the saw is not to be used.
• Do not expose the machine to moisture.
• Keep the table clean and free of wood sap.
• Keep the band saw clean, use a brush and dust extractor to remove dust and chips. Pay particular
attention to the motor’s air intakes and any openings where the dust can build up and prevent the blade
from running freely.