CO/Tech 18-1155, Original Instructions Manual

Page: 4 / 20

4
ENG
LI
SH
10 1
10 4
Getting started
1. Attach the wheels to the pressure vessel and the air filter (1) to the compressor (see fig.).
2. If a transportation cover is fitted on the oil filler hole (4), remove it and fit the proper cap.
3. Place the compressor in a dry and well ventilated place.
4. Make sure that it is stable and cannot tip over.
5. Make sure that the oil level is up to the red circle in the oil level window (3).
6. Connect the mains lead to a permanently installed 230 V wall socket.
N.B.
Before using the compressor for the first time: Open the drain tap (5) in the bottom of the pressure vessel,
switch the compressor on using the ON/OFF button (8) and let it run for 10 minutes to lubricate all the moving
parts. Close the drain tap.
Use
1. Check the oil level in the window (3).
2. Attach a suitable air tool: blow gun, spray gun, tyre inflator, etc.
3. If necessary: Read the instruction manual of the connected air tool and set the recommended working
pressure using the regulator (9).
4. When you have finished work and the compressor has been switched off, the air should be released
manually by pulling out the safety valve (7).
• Use SAE 30 compressor oil at temperatures over +10 °C.
• Use SAE 10 compressor oil at temperatures under +10 °C.