![CNCdrive DG4S Series Manual Download Page 7](http://html1.mh-extra.com/html/cncdrive/dg4s-series/dg4s-series_manual_2627877007.webp)
7
3.2 USB, Main and Encoder connectors
Description of the USB interface connector:
A 4-pin RM2.0 socket connector is provided for tuning and for making diagnostics on the
drive.
This connector plugs directly into our PRG01 USB programming stick and this cable con-
tains the USB driver electronics. For tuning connect the drive’s 4-pin socket to the PRG1
programming cable’s 4-pin socket with the cables supplied with the programming cable.
And connect the PRG1 circuit to the PC USB port via a standard USB A-B cable.
The USB connection is provided for configuration and monitoring purposes. These lines
are optically isolated from the device’s other parts and from the PC.
Note:
The
PRG01 USB programming
stick is not the part of the DG4S drive
package. This product
must ordered separately.
One programming stick can be
used to configure any number of drives, but not in the same time.
The drives can be configured/tuned with our Servoconfigurator3 software which can be
downloaded from our website for free of charge.
The software documentation can be found in the software package.
Download the latest tuning software from our website.
Description of the encoder connector:
A differential incremental encoder with A+, A-, B+ and B- signals has to be connected to
the encoder RJ45 connector.
The pinout of this connector is listed below.
1.
Ground
2.
5Volts (output from the drive to the encoder)
3.
NC (Do not connect)
4.
NC (Do not connect)
5.
A+ signal input
6.
A- signal input
7.
B+ signal input
8.
B- signal input
Summary of Contents for DG4S Series
Page 1: ...DG4S series DC Servo drive...
Page 21: ...21 CONTENTS...