6
2.3
Procedures of Assembling
1) Move the packing box to the working site and avoid strong shaking.
2) Disassemble the wooden packing box from top to bottom. Check whether the parts are complete or not
according to the packing list.
3) Lift the printer out by a forklift, and move it to the installation site.
4) Check if the printer is level.
5) Get rid of all the parts that stabilize the carriage holder, and install all the spare parts.
6) Move the carriage to the left of printer, then move back to the right manually. During this process, checks if
there are abnormal resistance and carefully inspect the belt & the encoder sensor are situated in proper
position.
7) Ground the printer. The grounded voltage should not be more than 0.3V, and the grounded resistance should
be less than 3Ω.
8) Connect the USB cable between printer and computer. Check if the wires and data cables are plugged in
properly.
9) Install the output and the rip software.
10) Turn on the printer, the carriage will automatically reposition. Keep your hand on the emergency button for
turning off the printer if problem happens suddenly.
11) Send a file to print to test the condition of the printer.
12) Install the printhead, dampers. Connect the damper to the Flush, click the Clean button to choose Depth
clean mode on the software, clean the dampers and the printhead at the same time.
13) Install the ink to the cartridge; fill ink for the first time by using Depth clean.
14) Print nozzle checking and observe the condition of printheads. It is recommended to keep a copy of the test
for reference in the future.
15) Printhead alignment.
16) Start to Print.
Chapter 2
Preparation and Procedures for Assembling
