CMX DVB 4800, User Manual

Page: 12 / 32

Start of operation and configuration
- 12 -
Do not connect your hi-fi’s phono input to the receiver; this can
damage your hi-fi-system.
For radio reception you need not turn your TV set on. To receive the
TV sound via your hi-fi system turn your TV set on.
1. Connect the coax cable to the receiver’s „COAXIAL“ connector.
2. Connect the coax cable to the digital audio amplifier.
3. Activate the receiver’s digital audio output in the menu item system
settings TV system.
4.4. Insert batteries
The battery compartment is at the rear of the remote control.
1. Insert two AAA batteries (1,5V) observing the polarity (+ and -) as
marked inside the battery compartment.
Point the remote control towards the IR receiver on the main unit.
(Range of 5m with 60° angle to both directions).
The lifetime of the battery is approximately 6 months with normal use.
To avoid damage remove the battery from the remote control during
extended periods of non-use.
5. Start of operation and configuration
5.1. Start of operation
See the details in chapter preparation (see 4.1 connection the system)
1. Select the AV channel on your TV set.
Some TV sets detect the satellite receiver’s output switching voltage
and switch SCART connection automatically to AV operation.
The satellite receiver’s main power switch is at the rear of the unit and
must be set to “ON”.
The default password is „
0000
“.
2. In the submenu
installation
select the item
Antenna connector
. Select
the antenna type.
3. In the submenu
Installation
select the item
Satellite list
.