CMT ORANGE TOOLS CMT11, Operating Instructions Manual

Page: 10 / 56

10
EN
www.cmtorangetools.com
Take care with sharp tools such as spatulas, saw blades
or cutting blades.
• Loosen the clamping plate (2) by pulling the quick-
release lever (1) completely open.
•
Hold the opening of the quick-install saw blade,
sanding plate or spatula toward the output spindle
which between cover clamp and clamping plate ,
push the accessory in and place it firmly onto the
locating pins.
• Fasten using the quick-release lever (1) at the lock
position as shown in the Fig. 1.
•
Remove the accessory in the apposite way.
WARNING: Do not use any unmatched
accessories.
WARNING: Check the tight seating of the ap-
plication tool/accessory.
lncorrect or not securely fastened applica-
tion tools/accessories can come loose dur-
ing operation and pose a hazard.
7.2) Mounting/changing the sand pa-
per (Not Included)
With fast hook and loop fixation.
• Position the sand paper and press by hand.
• Press on the sand paper by giving it a short, firm
push against the flat surface of sanding plate (8)
and switch on the power tool.
This ensures good adhesion and prevents prema-
ture wear.
•
lf the point has become worn, pull off the sand pa-
per, turn it through 120° and place it on again, or
change the sanding paper.
7.3 ) Mounting dust extraction hose
As shown in the Fig. 1.
8. OPERATION
8.1) Switching ON/OFF (Fig.2)
First check that the cable and plug are not damaged.
•
Connect the plug to the power supply.
• Switching the power tool ON: slide ON/OFF switch
button (4) forward onto position (I).
•
Switching the power tool OFF: slide ON/OFF switch
button (4) backward onto position (O).
8.2 ) Speed adjusting (Fig. 3)
The tool can be set at 6-speed adjustment positions. The
“1” position indicates the lowest and the “6” position indi-
cates the highest speed, you can adjust different speed by
turning the speed control dial (3) from “1” to “6” position.
The operator may have to vary the speed to optimize work-
ing efficiency.
8.3 ) Application tips
8.3.1) Selecting the Application
Tool/Accessory
Accessory Material
Plunge cut saw blade
wood Wooden materials,
plastic, gypsum and other
soft materials.
Shovel blade Wood, paint, carpet
adhesive, silicone and
other elastic
materials.
Base plate for sanding Depends on sanding
sheet.
8.3.2) Sawing
Use undamaged faultless saw blades only.
Deformed, blunt saw blades or saw blades
that are otherwise damaged can break.
Plunge cuts may only be applied to soft
materials, such as wood, gypsum plaster
boards, etc.!
Before sawing with saw blades in wood, particle board,
building materials, etc., check these for foreign objects
such as nails, screws, or similar. lf required, remove for-
eign objects or use saw blades for metal.