Mill Twin Cylinder Model Steam Engine v2 – Assembly Instructions v1.1
Copyright - Chiltern Model Steam Engines
Page 2.
Step by step instructions:
1.
Locate the parts as show in the following picture and as listed on the A3 Assembly Drawing
(a copy of which will have been included with the kit but also available for download from
). NOTE: for shipping purposes many parts will be packed
semi-assembled or in place, e.g. grub screws, bearings and eccentric rod.
2.
Fix the 2 Slider Tubes to the Base casting using the 8 M3 x 12mm cap screws. Make sure the
tubes are the right way up, see photos. NOTE: a long handle 2.5mm hex/allen key is best for
doing this. Check the ends of the screws do not extend out of the Base casting, file down the
screws flush or just below the surface if necessary.
