6
4. LED LIGHT INSTALLATION/
WINTERIZATION
4.1 PREPARING THE LED LIGHT
INSTALLATION
NOTE: Ensure that the pool meets
requirements of the National Electric Code
and all local codes and ordinances. A licensed
and certified electrician must install the
electrical system.
1.
The low voltage transformer must be
located at least 8 inches above the water
level, at least 4 inches above the ground
level, and at least 4 feet from the edge of
the pool.
2. All metal items within 5 feet of the pool
must be properly electrically bonded to a
reliable point of grounding.
3. Connect the male and female wire
connectors.
4. Feed cord through conduit from the
Laminar to the low voltage transformer.
Leave about 3 feet of cord coiled in the
bottom of the deck canister so that the
unit can be easily serviced.
5.
Connect all wiring to the low voltage
transformer. Install cover for the
transformer.
6. Test to make sure the light functions and
the wiring has been done correctly.
4.2 WINTERIZATION STEPS FOR AREAS
WITH FREEZING CONDITIONS
1.
Remove canister lid.
2. Carefully loosen and separate the garden
hose union on the water supply line inside
the deck canister.
3. Disconnect the male and female wire
connectors.
4. Blow water lines clear.
5.
Remove jet body assembly and then
pour out remaining water from the body
by rotating it in all directions. Continue
dumping water until all water is removed.
6. Store jet body and all attachment
hardware together in a safe, dry location.
FIGURE 5: Laminar DIMENSIONS
