23
Routing
In the routing section, all input signals (Wave Play 1/2, Wave Play 3/4, Analog In,
Digital In, Digital Mixer and Digital Play) can be routed to the three output pairs
(Analog Out 1/2, Analog Out 3/4, Digital Out). Almost any combination is possible.
Click the three buttons on the left-hand side to open a window in which you can
select the desired pair. Needless to say, if you intend to use the digital mixer, “Digital
Mixer” must also be selected on the input side, otherwise the signal will be sent
straight to the output, bypassing the faders.
The routing options of the UF400e
Analog Out 3/4 (Line / Headphone)
Use the two buttons at the lower right-hand side of the Control Panel to toggle the
analog output on the front panel between “Line” and “Headphone” levels. Set to
headphone level, the volume can be adjusted not only in the Control Panel, but also
—much more conveniently—with the knob on the front panel of the housing. An
LED on the front panel indicates that the headphone level is activated.
The ASIO panel
To open the ASIO panel, click the “ASIO” button (on the right-hand side of the
UF400e Control Panel). Use the slider to adjust the latency (i.e. the delay between
striking a key or a MIDI event and the output of the sound). If the value is too low
UF400e Firewire Audio Expansion Board Users Manual