7
NOTE: DURING THE SEARCH OPERATION, THE LIGHT
INDICATOR FLASHES MORE QUICKLY. THE LIGHT
INDICATOR STOPS FLASHING AND YOUR REMOTE
CONTROL LEAVES PROGRAMMING MODE IN THE
FOLLOWING CASES:
•
if no keys are pressed for 12 seconds
•
if you press keys other than those indicated
•
if the code search list is completed. In this case, visit
www.cme.it or contact the call center.
RE-PROGRAMMING YOUR REMOTE CONTROL
BY ENTERING THE CODE NOTED DOWN
If the remote control is no longer programmed because it has
been left without batteries for a long time or has flat batteries,
you can re-program it quickly as follows:
1
. Hold down the
and keys
simultaneously
until the
light indicator at the top starts to flash indicating that the
remote control is programming.
2
. Release the keys and, within 12 seconds, using the
and keys, enter the eight-sign code which you noted
down before. At the end,
three flashes
indicate that the code
has been saved correctly. If not, try the code entry procedure
again from
point 1
.
When you have programmed Easytel CME, note down the
code on the label in the battery compartment cover.
To find the code for your remote control:
1.
Hold down the and keys
simultaneously
until the light
indicator at the top starts to flash indicating that the remote
control is searching for the code.
2.
Release the keys and, within 12 seconds, press and
simultaneously.
3.
Release and and pay attention to the flashing of the
LED: a long flash corresponds to a
+
while a short flash
corresponds to a
-
. Note the sequence of the
8 flashes
and
note them down on the label in the battery compartment
cover, from left to right.
PROGRAMMED CODE NOTING
Once you have programmed
Easytel
, you can turn ON
your TV in three ways:
•
Press or .
•
Press .
•
Press and simultaneously: this sends the code
for
programme 1
.
To return to
programme 1
directly, press and
simultaneously.
USING YOUR REMOTE CONTROL
P
-
+
P
P
-
+
P
P
-
+
P
P
-
+
P
P
-
+
P
P
-
+
P
AV
AV
