7
F I T T I N G T H E BAT T E R I E S
Before programming and using the remote control, fit the batteries.
The remote control requires 2 new
AAA/LR03
batteries.
• Change the batteries if the light indicator starts to flash during use. The batteries are low.
• When you remove the batteries, fit the new ones within 5 minutes or you may have to reprogramme your
remote control.
• Make a note of the code for your TV on the adhesive label inside the battery cover in case you have to
reprogramme your remote control.
1
. Switch on the TV.
2
. Look for the brand of the television you want to programme
in the code list and make a note of the corresponding
code alongside
(e.g. PHILIPS 0025).
3
. Hold down the
MUTE
and
ON/OFF
keys together for 3
seconds until the light indicator starts to flash indicating
that the remote control is being programmed.
4
. Release the keys. Within 12 seconds, enter the brand
code previously identified (
e.g. 0025). The light indicator
flashes more quickly to indicate that the remote control
is ready for the search.
5
. Point the remote control towards the TV. Press and slowly
release the
ON/OFF
key several times,
stopping
when
the TV goes off.
6
. When the TV goes off, press the
OK
key to confirm.
Three flashes
indicate that the operation has been
completed correctly.
The quickest and easiest way to programme the remote control is
by consulting the website
www.cme.it
.
HOW TO PROGRAMME THE REMOTE CONTROL
PHILIPS
0025
To display and make a note of the code memorized by means of the search,
follow the instructions described in the paragraph CURRENT CODE DISPLAY.
NB: THE LIGHT INDICATOR STOPS FLASHING
The remote control exits programming mode and the light indicator stops flashing:
• if no keys are pressed for 14 seconds
• if an invalid brand code is entered
• if the code search list is completed. In this case, consult the website
www.cme.it
ADDITIONAL CHECK
Check that some of the other keys, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar remote
control but not the right one. In this case, repeat the search procedure starting from
point 3
, entering the
code previously used (e.g. 0025).
+
5 SEC.
+
+
+
