CMD solutions ergo H, Information And Instruction Sheet, Page: 2 / 2

Vision H with Integrated Power - Information and Instruction Sheet
CMD Ltd, Sycamore Road, Eastwood Trading Estate, Rotherham, S65 1EN. United Kingdom.
T
: +44 (0) 1709 829 511 |
F
: +44 (0) 1709 378 380 |
E
: enquiries@cmd-ltd.com |
W
: www.cmd-ltd.com
Part Number 134201. Issue 2 Date: 28/09/2020
Cleaning, Storage and Maintenance
Service Components: Available to order.
Cleaning &
Maintenance: Dry cloth, no abrasives or solvents to
be used on the product surface.
Handling & Storage: Do not drop.
Warning
Do not exceed the recommended maximum weight of 5kgs.
Do not extend the monitor past the front edge of the base
plate.
Assembly Instructions
1. Position the base in a suitable position making
sure the M8 fixing screw is at the back of the
desk or table (fig. 03). Note: the integrated power
module is pre-installed on the base.
2. Position the pole over the M8 fixing screw and
secure by turning the pole clockwise until hand
tight (fig. 04).
3. Attach the Single VESA Head to the pole (fig. 05
& 06).
4. Install the cable management clips to the pole (fig.
06).
5. Connect the monitor to the VESA using the
screws provided (fig. 07) and re-attach the VESA
to the single monitor arm (fig. 08).
6. The VESA head may tighten or loosen after
prolonged use so may need adjusting (fig. 11).
Weight Adjustment
+ Kg - Kg
fig. 11
fig. 03 fig. 04
fig. 05 fig. 06
fig. 07 fig. 08
Product Assembly
Dual Screen Assembly Instructions
1. Attach the Single VESA Head to the centre of the
Dual Screen Razor Mount using the 4x M4*12
screws provided (fig. 09).
2. Connect the monitors using the 8x M4*12 screws
and washers provided (fig. 09).
fig. 09 fig. 10