Club Car XRT 950 2009, Maintenance And Service Manual

Page: 53 / 256

ACCELERATOR AND BRAKE PEDAL GROUP Accelerator Pedal Removal – From Early-2012 Model Year
5
ACCELERATOR PEDAL REMOVAL – FROM EARLY-2012 MODEL YEAR
See General Warning on page 1-2.
9
7
7
8
10
8
5
3
3
2
1
6
4
5
2507
Figure 5-19 Accelerator Pedal – From Early-2012 Model Year
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Remove the under-pedal closeout panel. Drill out rivets and carefully pull the panel out and down over the
pedals
(Figure 5-20, Page 5-10) .
CAUTION
• Be sure not to damage any components as a result of the drilling operation.
3. Disconnect the Z-shaped end (1) of the accelerator cable (2) from the pedal (3) (Figure 5-19, Page 5-9) . See
following NOTE.
NOTE: If the accelerator cable (2) does not have enough slack to allow disconnection at the pedal (3), it may be
necessary to release the accelerator cable anchor (4) from pedal bracket (5). To do so, compress the tines (6)
of the cable anchor and pull the cable from the bracket (5).
2009-2012 XRT 950 Maintenance and Service Manual Page 5-9