Club Car XRT 950 2009, Maintenance And Service Manual

Page: 30 / 256

4
Front Body BODY AND TRIM
6. Carefully remove front fascia from vehicle.
FRONT FASCIA INSTALLATION
1. Move front fascia in place and connect headlight wiring (Figure 4-5, Page 4-5) .
2. Carefully insert molded-in lower front fascia retaining hook into receiving slot in the fascia mounting frame.
3. Secure the fascia to the fascia mounting frame using four bolts. Tighten the hardware to 22 in-lb (2.5 N·m).
4. Secure the front of the each fender to the lower corner of the fascia using two torx-head screws. Tighten screws
to 22 in-lb (2.5 N·m).
FRONT COWL REMOVAL
1062
Figure 4-6 Front Cowl Removal – under side of outer ends
of front fascia
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Remove the two torx-head screws that secure the front of each fender to the lower corner of the fascia (Figure
4-6, Page 4-6) .
1135
Figure 4-7 Front Cowl Removal – removing under hood
bolts
3. Remove bolts located under hood, inside front cargo compartment on front top edge (Figure 4-7, Page 4-6) .
Page 4-6 2009-2012 XRT 950 Maintenance and Service Manual