Club Car XRT 950 2009, Maintenance And Service Manual

Page: 240 / 256

18
Driven Clutch CLUTCHES
DRIVEN CLUTCH DISASSEMBLY
The following service tool is required to disassemble and assemble the driven clutch. It is available from a service
parts representative:
• Driven Clutch Disassembly Tool (CC P/N 103601701)
1199
Figure 18-18 Disassembly Tool Base In Vise
1200
Figure 18-19 Place Driven Clutch Onto Tool Base
1. Secure Driven Clutch Disassembly Tool in a vise by gripping the large nut, located under base of tool, in jaws of
vise
(Figure 18-18, Page 18-12) .
2. Place the driven clutch onto the tool base with the cam (6) oriented up (Figure 18-19, Page 18-12) .
1203
Figure 18-20 Place Alignment Marks On Cam and Both
Sheaves
1202
Figure 18-21 Center Disassembly Tool Collar On Cam
3. Mark cam (6) and both sheaves (2 and 4) for reassembly (Figure 18-20, Page 18-12) .
4. Note holes in cam (1, 2, 3 and 4) and sheave (A, B, and C) used to locate spring ends. See following NOTE.
NOTE: The numbers (1, 2, 3 and 4) in cam and letters (A, B, and C) in sheave are cast or stamped next to their
respective holes.
5. Place the disassembly tool collar onto the threaded post and center collar on cam (6) (Figure 18-21, Page 18-12) .
Page 18-12 2009-2012 XRT 950 Maintenance and Service Manual