Club Car XRT 950 2009, Maintenance And Service Manual

Page: 211 / 256

SECTION 15 – EXHAUST SYSTEM
15
DANGER
• See General Warning on page 1-2.
WARNING
• See General Warning on page 1-2.
MUFFLER REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Loosen the clamp securing the exhaust pipe in the muffler (Figure 15-1, Page 15-1) . See following WARNING.
WARNING
• Hot! Do not attempt to service hot engine or exhaust system. Failure to heed this warning could
result in severe burns.
3. Remove the nut and bolt securing the bottom of the muffler to the chassis (Figure 15-2, Page 15-1) .
4. Pull the muffler off of the exhaust pipe and remove from vehicle.
1294
Figure 15-1 Muffler Clamp
1028
Figure 15-2 Muffler Mounting Hardware
MUFFLER INSTALLATION
1. Installation is the reverse of removal.
2. Tighten the lock nut to 200 in-lb (22.4 N·m).
3. Tighten the clamp hardware to 200 in-lb (22.4 N·m).
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles on page 1-4.
2009-2012 XRT 950 Maintenance and Service Manual Page 15-1