Club Car XRT 950 2009, Maintenance And Service Manual, Page: 107 / 256

REAR SUSPENSION Trailing Arm Removal
9
1293
Figure 9-6 Rear Lateral Link to Chassis Hardware
Orientation
TRAILING ARM REMOVAL
See General Warning on page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page 1-4.
2. Pry out the thin axle nut flange where it is staked to the groove in the halfshaft (Figure 9-7, Page 9-3) and
loosen the axle nut (Figure 9-8, Page 9-3) .
951
Figure 9-7 Undo Staked Flange Of Axle Nut
1066
Figure 9-8 Loosen Axle Nut
3. Lift and support the rear of vehicle and remove the wheel. See Lifting The Vehicle, Section 3, Page 3-4.
4. Raise the cargo bed and secure with the bed locking pin. See Cargo Bed, Section 4, Page 4-20.
5. Remove the bolt securing the brake hose and cable to the driver side trailing arm (Figure 9-9, Page 9-4) .
2009-2012 XRT 950 Maintenance and Service Manual Page 9-3