Club Car Turf 2 XRT 2002, Owner'S Manual Supplement

Page: 11 / 12

Rear Fender Installation
2002 Turf 2 XRT Owner’s Manual Supplement Page 11
4. Make sure fender is correctly aligned in the vehicle by placing the outer fender rib to the outside of the
upper side panel, and as far forward as possible, leaving no gap between the fender and side panel
(Figure 2) .
5. Drill three 5/16 inch holes through the fender: Two through the outside holes in the front mounting
bracket, and one through the slotted hole in the top mounting bracket (Figure 2) .
6. Loosely install bolts (1), large flat washers (2), small flat washers (4), and lock nuts (3) in the front mount-
ing bracket holes.
7. Install bolt (1), small flat washer (4), large flat washer (2) and lock nut (3) in the top mounting bracket hole
as shown (Figure 2) .
8. Tighten mounting hardware at both front mounting bracket holes, then both top mounting bracket holes,
to 35 in-lb (4.0 N·m).
9. Repeat steps 3-8 for the other rear fender.
10. Lower cargo bed.
Figure 2 Drill Additional Mounting Holes
Front of
Vehicle
DRIVER SIDE SHOWN
4
2
3
2
1
3
4
1
Before drilling holes,
move fender as far
forward as possible.
Do not allow any gap
between fender and
side panel.
UPPER
SIDE PANEL
TOP MOUNTING BRACKET
FRONT MOUNTING
BRACKET
Fender rib to
outside of
side panel