Club Car Turf 1 2005, Owner'S Manual

Page: 29 / 68

Bed Latch
Page 20 2005 Turf Vehicle Owner’s Manual
STOPPING THE VEHICLE
ý
WARNING
• Driving through water may affect the brakes. After driving through water, check effectiveness
of the brakes by gently pressing the brake pedal. If the vehicle does not slow down at the
normal rate, continue to press the brake pedal until the brakes dry out and normal
performance returns.
ý
CAUT ION
• When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator
pedal.
To stop vehicle, release the accelerator pedal and press the brake pedal until vehicle comes to a complete
stop.
PARKING AND LEAVING THE VEHICLE
1. After coming to a complete stop, firmly press the park brake pedal until it locks. This will prevent the vehi-
cle from rolling.
2. Turn the key switch to the OFF position and place the Forward/Reverse handle or switch in the NEU-
TRAL position. Remove the key.
• IQ System vehicles only: When the Tow/Run switch is in the RUN position (with the Forward/Reverse
switch or key switch in any position), the “zero speed detect” function will prevent the vehicle from rolling
at more than 1 to 3 mph (1.5 to 4.8 km/h) unless the accelerator is pressed. This prevents the possibility
of a parked vehicle (with the park brake disengaged) rolling away too fast to be overtaken on foot.
• Gasoline vehicles only: Turn the fuel shut-off valve to the closed (OFF) position when the vehicle is
not in use.
BED LATCH
The electric and gasoline Turf 1 and Turf 2 are equipped with a bed latch on the driver side of the vehicle as
standard equipment
(Figure 17) . To lift the bed, pull the latch handle toward the rear of the vehicle and lift the
bed.
To close the bed, lower it gently until the bed latch engages. DO NOT drop the bed.
ý
WARNING
• Keep hands and fingers clear of crush area between the bed and the seat back support.