Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 40 / 414

4
Kick Plate – EFI Gasoline Vehicles BODY AND TRIM
KICK PLATE – EFI GASOLINE VEHICLES
See General Warnings on page 1-2.
KICK PLATE REMOVAL
1. Remove floor mat. See Floor Mat and Retainers on page 4-8.
2. Remove three screws (1) that hold the kick plate (2) to the vehicle (Figure 4-7, Page 4-10) .
3. Remove the two front screws (3) that hold the beauty panel to the vehicle. Raise the forward portion of the rear
beauty panel to disengage it from the tabs on the upper portion of the kick plate.
4. Remove kick plate from vehicle.
KICK PLATE INSTALLATION
1. Position the kick plate (2) on the vehicle and secure with three screws (1). Ensure front lower edge of rear beauty
panel mates with the kick plate
(Figure 4-7, Page 4-10) . Tighten screws to 3.3 ft·lb (4.5 N·m).
2. Install two front screws (3) to secure the rear beauty panel. Tighten screws to 3.7 ft·lb (5 N·m).
3. Install floor mat. See Floor Mat and Retainers on page 4-8.
1
2
3
620a
Figure 4-7 Kick Plate – EFI Gasoline Vehicles
Page 4-10 2019 Precedent Villager 2 Maintenance and Service Manual