Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 346 / 414

21
Fuel Line GASOLINE VEHICLE - FUEL SYSTEM
1
3
2
1. Pull out locking clip.
2. Push in on release tab.
3. While pushing in on release tab, pull fuel line off nipple.
1
2
1. Push fuel line onto nipple until it locks into place.
2. Push in locking clip until fully seated.
3050
Figure 21-12 Fuel Line Connector – To Disconnect
3051
Figure 21-13 Fuel Line Connector – To Connect
FUEL LINE INSTALLATION
1. At fuel tank:
1.1. Clean the nipple on top of fuel pump module.
1.2. Push fuel line fully onto nipple until it locks in place (Figure 21-13, Page 21-18) .
1.3. Engage locking clip by pushing in until fully seated and completely prevents the line from being pulled
off nipple.
2. At engine:
2.1. Connect fuel line to throttle body and secure with spring clamp. See following DANGER.
DANGER
• Ensure line is connected properly to avoid a leak that can cause a fire.
• Make sure fuel line is the correct length and properly routed. Failure to heed this warning could
result in damage to fuel line and fire.
Page 21-18 2019 Precedent Villager 2 Maintenance and Service Manual