Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 337 / 414

GASOLINE VEHICLE - FUEL SYSTEM Engine Control Linkages
21
GROUND SPEED
NOTE: If possible, the manufacturer recommends measuring ground speed when setting engine RPM.
This vehicle should reach the forward ground speed specified in Section 2 – Vehicle Specifications . See How to
Measure Ground Speed on page 21-12.
GOVERNOR CABLE
Governor Cable Removal
2
1
3
B = 2.87 in. ± 0.039 (72.9 mm ± 1)
3132
Figure 21-5 Governor Cable At Throttle Body and Power
Limiter Screw Gap Adjustment
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At engine:
3.1. If equipped, remove air deflector from top of engine.
3.2. Disconnect “Z” fitting of governor cable (1) from throttle lever (2) (Figure 21-5, Page 21-9) .
3.3. Unsnap governor cable (1) from throttle body bracket (3).
4. At transaxle:
4.1. Disconnect “Z” fitting of governor cable (1) from governor arm (4) (Figure 21-6, Page 21-10) .
4.2. Loosen jam nuts at governor bracket (5) and remove cable (1) from vehicle.
Governor Cable Installation and Adjustment
1. At engine:
1.1. Snap governor cable (1) into throttle body bracket (3) (Figure 21-5, Page 21-9) .
1.2. Connect “Z” fitting of governor cable (1) to throttle lever (2).
1.3. If equipped, install air deflector on top of engine.
2. At transaxle:
2.1. Slide bellows off threaded end of cable housing, separate jam nuts and place threaded end into governor
bracket (5) (Figure 21-6, Page 21-10) .
2.2. Finger-tighten jam nuts.
2019 Precedent Villager 2 Maintenance and Service Manual Page 21-9