Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 296 / 414

19
Key Switch
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
KEY SWITCH
See General Warnings on page 1-2.
TESTING THE KEY SWITCH
See Test Procedure 5 – Key Switch (Start Circuit) on page 18-19.
See Test Procedure 6 – Key Switch (Engine Kill Circuit) on page 18-19.
KEY SWITCH REMOVAL
1. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
2. Remove the instrument panel.
2.1. Remove three screws (1) from the instrument panel (2) (Figure 19-19, Page 19-18) .
2.2. Rotate the instrument panel up and away from the dash to disengage the tabs at the top of the instrument
panel.
2.3. Disconnect the electrical connector (3) to the instrument panel.
2
1
1
3
4
9
6
8
2433
Figure 19-19 Instrument Panel Removal
703
Figure 19-20 Key Switch
3. Disconnect the wires from the key switch.
4. From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (4) and
remove the key switch cap (8). Hold the key switch and remove the switch retaining nut (6) from the outside of
the instrument panel
(Figure 19-20, Page 19-18) .
Page 19-18 2019 Precedent Villager 2 Maintenance and Service Manual