Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 283 / 414

GASOLINE VEHICLE - ELECTRICAL
COMPONENTS Starter/Generator
19
39
36
35
32
33
33
40
41
43
1342
Figure 19-6 Output End Cover Assembly, Armature and Housing
BEARING CLEANING AND INSPECTION
1. Using a clean cloth, wipe the carbon dust from the two bearings. Inspect bearings by spinning them by hand and
checking for both axial (A) and radial (B) play
(Figure 19-7, Page 19-5) .
2. Replace the bearing if it is noisy, does not spin smoothly, or has excessive play. Check the bearings and replace if
rusted, worn, cracked, or if there is an abnormal color change in the metal of the bearing. Bearings should be
replaced if there is extensive wear or pitting on the balls or on the rolling surfaces. Do not remove the bearings
unless they are to be replaced.
A
B
493
Figure 19-7 Bearing Play Inspection
2019 Precedent Villager 2 Maintenance and Service Manual Page 19-5