Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 266 / 414

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 10 – Neutral Lockout Limit Switch – Pedal-Start Vehicles Only
See General Warnings on page 1-2.
NOTE: This is a continuity test.
This switch is located on the transaxle. A black/light blue wire, a red wire, and a blue wire are connected to this
limit switch with a 3-pin connector.
1. If necessary, see Testing Basics on page 18-10.
2. Disconnect battery and spark plug wire(s).
See Disconnecting the Battery- Gasoline Vehicles on page 1-3.
3. At transaxle, disconnect neutral lockout limit switch three-wire lead from main wire harness.
4. Check to be sure the cam lobe on the shift lever is pressing the neutral lockout limit switch as the Forward/Reverse
shifter is being shifted. The limit switch should make an audible click as it is pressed. If it does not, check for wear
on the cam lobe and replace shift lever if necessary.
5. Check the following terminals for no continuity with the lever released and continuity with the lever engaged
(Figure 18-7, Page 18-24) :
PROBE BETWEEN LOCATIONS TEST RESULT
With lever released: No continuity
Between terminal 1 “COM” (black/light blue wire) and terminal 2 “NO”
(red wire)
With lever pressed: Continuity
With lever released: Continuity
Between terminal 1 “COM” (black/light blue wire) and terminal 3 “NC”
(blue wire)
With lever pressed: No continuity
3028
Figure 18-7 Neutral Lockout Limit Switch Test
6. If switch does not work as stated in previous step, replace switch. See Neutral Lockout Limit Switch Removal,
Section 19, Page 19-20.
Page 18-24 2019 Precedent Villager 2 Maintenance and Service Manual