25
Drive Clutch
TORQUE CONVERTER (GASOLINE VEHICLE)
DRIVE CLUTCH DISASSEMBLY
CAUTION
• The drive clutch is balanced as an assembly. Before disassembly, make match marks on the drive
clutch hub and on the moveable face assembly so they can be reassembled in the same positions
(Figure 25-8, Page 25-8).
1.
Make match marks on the drive clutch hub and on the moveable face casting
.
2.
Remove the drive clutch hub (1)
:
2.1. Remove the three plugs (22) from the clutch puller attachment holes
2.2. Thread the center bolt of the Drive Clutch Hub Puller (1) (P/N 1014497) into clutch until the stop nut touches
the clutch, then back the bolt out one-half turn
2.3. Thread the three small bolts of the puller (1) into corresponding holes in the clutch. Tighten bolts evenly,
making sure the face of the puller plate is parallel to the face of the clutch
.
2.4. Unscrew the puller center bolt out of the clutch to pull drive clutch hub off.
(CCI P/N 1014497)
1
598
Figure 25-8
Mark Drive Clutch Hub
599
Figure 25-9
Remove Drive Clutch Hub
3.
Remove the thrust washer (11) from the moveable face (14)
.
4.
Remove the drive buttons (3) by removing the screws (1), flat washers (2), and drive button take-up springs
(4) as shown
Page 25-8
2014 Precedent
®
Golf Car Maintenance and Service Manual
Summary of Contents for Precedent 2014
