Club Car Precedent 2014, Maintenance And Service Manual

Page: 384 / 548

24
Unitized Transaxle Removal UNITIZED TRANSAXLE (GASOLINE VEHICLE)
NOTE: Place the blocks so they will support the engine when the transaxle is detached and moved away from
the engine.
16. Remove the drive belt.
16.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch sheaves
apart. Roll the belt counterclockwise while pulling it off driven clutch (Figure 24-35, Page 24-16) .
6 in. (15.24 cm)
579
Figure 24-34 Position Powertrain on Wood Blocks
580
Figure 24-35 Remove Drive Belt
17. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle (Figure 24-36,
Page 24-16) .
18. Loosen, but do not remove, the governor arm retaining bolt (1) (Figure 24-37, Page 24-16) . Remove the
governor arm from the shaft. Do not disconnect cables.
1
581
Figure 24-36 Driven Clutch
582
Figure 24-37 Governor Arm
19. Remove screws (1) securing the governor cable bracket to transaxle (Figure 24-38, Page 24-17) .
20. Remove screws (1) securing the accelerator cable bracket to transaxle (Figure 24-39, Page 24-17) .
Page 24-16 2014 Precedent ® Golf Car Maintenance and Service Manual